In order to successfully record a file and play it back at the same time, you must do the following.
1. Ensure that the file will NEVER start playing back until the record process has started.
2. Create a Custom Command Timer Event for the length of this recording. This will keep the recording playing once it starts playing for XXX seconds. XXX seconds is the length of the recording.
If you are recording a 5 minute newscast, then create a custom command called Timer 300
In your Scheduling Shells, place the Timer 300 command as the event just prior to the play event for the newscast.
3. Create a Custom Command End Timer Event This will allow the DJB to continue down the on-air screen after the newscast plays.
Create the custom command called End Timer
In your Scheduling Shells, place the End Timer command as the event just followingthe newscast.
