This is the Map Network Drives screen. this is where you setup all of the network drives on your production systems.
![1](drex_bullet_1.png) Drive Drop down
![1. Drive Drop down](drex_module_2_6_2_control_1.png) Choose a Drive Letter that is no where near any existing drive letters that you may already have on your Production computer system. We always recomment drive M:
If you have more than 1 onair system, just use N: for the next drive letter when you setup the mapping for that drive.
|
![2](drex_bullet_2.png) Browse... button
![2. Browse... button](drex_module_2_6_2_control_2.png) Browse the Microsoft network computers.
|
![3](drex_bullet_3.png) Folder
![3. Folder](drex_module_2_6_2_control_3.png) You can either browse for the drive that you want to map or you can just type it in in the following format. \\Computername\shareddrivename
|
![4](drex_bullet_4.png) Reconnect at logon check
![4. Reconnect at logon check](drex_module_2_6_2_control_4.png) This box is always checked.
|
![5](drex_bullet_5.png) Finish button
![5. Finish button](drex_module_2_6_2_control_5.png) Then hit Finish and it will connect your new network drive and open a folder showing the contents. You can close that window now.
|