A Command Event is command that you would like to send to a Broadcast Tools Switcher prior to the Record event starting or just after the recording has completed
These are usually commands to turn an audio channel on the BTSS switcher on and off to the record line in on the audio card.
Make sure that you space these commands away from the actual Record Event by at least 5 seconds to ensure that there is enough time for the command to work prior to or following the Record Event.
You can only enable Background Recording on an On-Air System Only.
If you set this system to a production system and go into the Background record screen, Recording enabled will be deselected automatically and you must remove the Production System setting in Master Settings and return here to enable it again.
A record event is is the actual audio recording that you want to set up for recording.
A Command Event is command that you would like to send to a Broadcast Tools Switcher prior to the Record event starting or just after the recording has completed
This will allow you to fine tune your events on this Background Record List.
You can only enable Background Recording on an On-Air System Only.
This will allow you to delete events on this Background Record List.
Choose the Audio Card and Input Channel that you would like to record from while doing a background record session.