How to Trim Heads & Tails
To activate the WAV Editor simply right mouse and click to open the audio file in the editor.
Figure 1: Select Edit Audio File
Figure 2: WAV Editor ZOOM Drag Bar to open an audio file waveform.
Drag the rear handle to the left until the front of the file is cleary visible - as in example, Justin Timberlake - Can't Stop
the audio file has some dead air at the front of the file. Highlite the dead air audio by back dragging the mouse
Figure 3: Note the audio file has dead air - wich would result in a sloppy play-out when started.
Figure 4: Back drag the mouse by Click and back drag - check the highlite by Play Selected to insure no audio
has been marked - then proceed to CUT the Highlited area by selecting from FILE\Cut
Figure 5: Cut out the dead air, check your file by PLAY, if all good SAVEW & EXIT button
For Trimming Tails of the audio fileif and only if required, reverse the process by dragging the Bar in Figure 2
Left to Right to ZOOM in on the tail of the audio cut.
